|
BODY
Comes complete with doors, hood, and trunk lid
Hand laid fiberglass mat.
Rolled edges in cockpit for a cleaner, more refined appearance.
Inner liners installed on doors and trunk.
Original style latches, headlights, marker lights, rectangular taillights, and windshield.
Le Mans Gas Filler Cap
CHASSIS
Frame rails - 4 120 wall DOM 1020 Steel.
Birdcage - Ύ tube, .083 DOM.
Floor pans, Dropped Foot-box, and Transmission Tunnel - 14 gauge Steel.
Remaining inner panels - .050 Aluminum.
Motor Mounts - Billet Aluminum for 351W and FE
Door hinges Custom designed Billet Aluminum.
Quick Jacks - hot rolled Steel 5/16.
All tabs, mounts, ground studs, and anti-roll bar mounts installed on chassis; no welding or modifications necessary.
Standard powder coating gloss black.
Custom manufactured Aluminum radiator.
Custom designed and purpose built baffled 20 Gal Aluminum fuel tank.
Steel Side Pipes
SUSPENSION
Billet Aluminum upper and lower control arms w/ adjusters.
Billet Aluminum front and rear uprights.
Billet Aluminum front and rear cantilever rocker arms.
Billet Aluminum brake caliper mounts.
Billet Aluminum steering arm.
18,000-psi rod ends.
CV Joints and axles
Coil-over shocks
5 lug hubs front and rear
STEERING
Woodward Rack and Pinion steering rack.
Steel steering shaft U-joints.
Stainless Steel steering shaft.
Custom manufactured Billet Aluminum steering column, complete with turn signal assembly.
Moto-Lita 14 Steering Wheel
BRAKES
Front Wilwood Forged Billet Aluminum 4-piston calipers with 13 rotors.
Rear Wilwood Forged Billet Aluminum 4-piston calipers with 11 21/32 rotors.
Pedal Assembly Wilwood triple reservoir.
FLUID LINES
Brake Lines Stainless Steel hard lines.
Flex Lines to Calipers Braided Steel flex lines.
Fittings AN fittings throughout.
INTERIOR
Cobra Classic Seats.
1 ½ Steel DOM roll bar.
Autometer Classic Cobra gauges:
180 mph reverse speedometer.
8000 RPM tachometer
Oil Pressure
Oil Temperature
Water temperature
Amp Meter
8 circuit wiring harness
Dash board
Head Light Switch
Items not included in kit
Complete Engine
Transmission
Shifter Handle
Flywheel, Clutch, Throw out bearing, Bellhousing
Drive line
Rear 8.8 ford center section
Headers
Tires and wheels
Lug Nuts (Bolt on wheels)
Body prep and paint
All fluids
Radiator hoses and clamps
Fuel lines and hoses and clamps
Emergency brake
Battery and cables
Carpet
Seat Belts
Speedo Cable
Misc. Hardware
Misc. Electrical Terminals
Tools needed to build kit
Wrenches
Socket set
Screw drivers
Torque Wrench
Allen Wrenches
Rubber Mallet
Electrical Terminal Crimpers
Ball Joint Socket
Clutch alignment tool
Drill motor & #30 drill bits
Pop rivet gun
Tin snips
Clamps
Floor Jack
Jack Stands
Engine hoist
|
